TEMPERATURE SETTING
For Single Zone
•
The temperature setting range is 5-22 ºC (41-72 ºF).
•
Directly touch the
•
The fi rst touch on
window. If the appliance runs after a power failure (or unplugging), the previous set temperature
does not exist and is replaced by the defaulted temperature at 12ºC.
•
Touch the mark
decrease the set temperature by 1ºC.
•
The digital will change to display the real temperature of the inside cabinet after 10 seconds
without being touched.
Note: For the fi rst time to use the appliance or to restart the appliance after having been shut off for
a long time, you may fi nd a few degrees variance between the set temperature and the displayed
temperature. It is normal and everything of the appliance will be in the order after a few hours running
SELECTING FAHRENHEIT(ºF) & CELSIUS (ºC) DISPLAY
For Single Zone
Touch the marks
the Fahrenheit and Celsius display.
For Dual Zone
Directly touch the mark
the same time.
CARE AND MAINTENANCE
CLEANING THE WINE COOLER
•
Turn off the power, unplug the appliance, and remove all items.
•
Wipe the inside surfaces with a sponge and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart (approx. 1 litre) of warm water.
•
Wash the shelves with a mild detergent solution. Allow wooden shelves to dry.
•
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical
parts.
•
Wipe the outside cabinet with warm water and mild liquid detergent. Wipe dry with a clean soft
cloth.
•
Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
or
mark to set the wine cooler temperature as you want.
or
mark will recall the previous set temperature displayed in the digital
to increase the set temperature by 1ºC. On the contrary, touch the mark
with 2 fi ngers at the same time and hold for 5 seconds, you can interchange
, you can interchange the Fahrenheit and Celsius display for both zones at
21
to
GB