Controls - Pelgrim DSG860 Série Notice D'utilisation

YOUR COOKER HOOD

Controls

EN 6
Switching the fan on and off
1. Select the desired extraction setting by touching the corresponding
speed setting keys.
The cooker hood switches on.
2. Quickly press and release the on/off key.
The cooker hood switches off.
Switching on intensive setting
1. Quickly press and release the intensive mode key.
The intensive setting (boost setting 'B') is switched on for 5 minutes.
The previous extraction setting will be reactivated after this period.
2. Press the on/off key or any other key to stop the intensive setting at
any time.
Switching the lighting on and off
1. Press the lighting key.
The lighting comes on.
2. Press the key again and the lighting goes off.
Saturation indicator for grease filter
After 40 operating hours, speed setting key 1 starts blinking. When this
indication appears, the grease filter must be cleaned.
To reset the indicator (the hood is switched on), touch and hold the
on/off key until you hear an acoustic signal. Speed setting key 1 stops
blinking.
Saturation indicator for activated carbon filter
After 160 operating hours, speed setting key 2 starts blinking. When
this indication appears, the activated carbon filter that has been
installed must be cleaned or replaced.
To reset the indicator (the hood is switched on), touch and hold the
on/off key until you hear an acoustic signal. Speed setting key 1 stops
blinking.
In default mode the active carbon filter indicator will not switch on.
If the extractor hood is used in recirculating mode, then the activated
carbon filter indicator must be switched on.