Bimar TE.HC17RBN Mode D'emploi page 12

 To taper hair down to the neckline, use attachment comb in position "1". Comb hair, check for
uneven spots and outline sideburns and neckline (16).
CUTTING WITHOUT THE COMB ATTACHMENT
To cut the hair with the help of a comb or your fingers as well as to cut the outlines, you do not need
the comb attachment.
Turn the locking knob to the left to the  position.

 Take off the comb attachment by pulling it holding it by the sides. (see page 2, B 6 and 7)
Cutting hair with the help of a comb or your fingers
Remove the comb attachment carefully, as explained in the previous paragraph.
Raise a wisp of hair with the help of the comb (17), or take the wisp between your fingers (18).
Take the wisp through the comb or fingers until only the desired hair length remains under the
comb/fingers. Cut the hair that is above the comb or fingers with the hair clipper (19 and 20).
Cutting hair with the integrated thinning function
The thinning function allows you to thin out your hair at some places to change the volume of the hair
cut.
 Remove the comb attachment before activating this function. (see paragraph "CUTTING
WITHOUT COMB ATTACHMENT".
 Turn the locking knob to the
of the appliance and partly covers the blades. This reduces the number of teeth and as a
consequence it also reduces the amount of hair that will be cut.
 Take the wisp through the comb or fingers until only the desired hair length remains under the
comb/fingers and cut the hair that is above the comb or fingers with the hair clipper.
Outlining

Outlining requires no attachments.

Comb hair into the required style. Position clipper between the sideburns and the ear. Make sure
the outer edge of the blade is against the hairline. With the outline of the hair as your guide, slowly
move the clipper around the ears (12). For the back of the neck and the sideburns, hold the clipper
upside down (13), and move downwards holding it against the skin at the length desired.
CUTTING A BEARD
 Lead the appliance against the grain of the beard.
 Comb the beard hair with the supplied comb so that it stands as high as possible, all in the same
direction.

Put the comb attachment on the appliance and slide it to the desired cutting setting.

Switch on the appliance and cut the beard.
Cutting the outlines of the beard
 Remove the comb attachment from the appliance.
 Hold the appliance in diagonal position with the front side pointing away from you.
 Start with the chin and cut backwards.

Follow the chin line and cut the longer hair at the outside of the beard.
Styling the beard
Hold the appliance vertically in front of your face, with its front side pointing away from you.
Start with the shortest areas of the beard and cut the hair directly under the beard line moving down.
Thinning and sharpening
Take the supplied comb and bring the beard hair in the desired shape.
Hold the appliance with its front side pointing away from you and cut the hair tips by moving down.
position (see page 3, E, 24). This way, a metal plate comes out
12/28