Standby Mode - Imetec Q8601 Mode D'emploi

take it out. [Fig.B1]
3. Open the rubber cap (1) positioned on the rear of the reservoir
(2) making sure not to tear it when you do so.
4. Take the top cap off the bottle (11) and place the tip in the
EN
larger hole of the water reservoir (2). While filling, hold the
water reservoir (2) slightly tilted with the rounded part facing
downwards.
5. Fill the reservoir (2) up to the level of the smaller hole.
6. Close the rubber cap (1) and make sure that the tank (2) is
completely dry before putting it back in place.
7. Slide the reservoir (2) in its seat towards the front of the
appliance until you hear a "click". [Fig.B2]
ON / OFF
NOTE: Always keep the heating plates clean to ensure that
the straightener offers the best performance.
1. Connect the power cable (4) to the mains.
2. To turn the straightener on, slide the ON/OFF button (6) to the
left, positioning it on the required temperature (170°C - 200°C
- 230°C).
NOTE: For particularly full and thick hair, set it at a higher
temperature. For thin and fine hair, set it at a lower temperature.
When in doubt, always start at a lower temperature and
increase it until you find the ideal setting.
3. The operating LED (7) starts to flash. The straightener is ready
for use when the LED stops flashing.
4. When you have finished styling your hair, switch the appliance
off by sliding the button (6) to the right to O and disconnect it
from the socket. Wait for the appliance to cool down. Disconnect
the plug and let the appliance cool completely.
STAND-BY MODE
The straightener features the auto-off function after 60 minutes of no
use.
To turn the appliance back on, turn it off by setting the button to 0 and
turn it back on by selecting the required temperature again.
OPERATING MODE
PREPARING YOUR HAIR
• Your hair must be dry and must not have any cosmetic styling
products in it.
• Before straightening your hair, carefully comb any knots out.
INSTRUCTIONS FOR USE
16