Datalogic STAR Modem Guide Rapide page 22

UK/US
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
-
STAR Modem™ is a Class III equipment according to the EN-60950 Electrical
Safety Standard.
CLASS III Equipment:
This equipment is intended for use with UL or CSA Certified, detachable, Class 2
Power Supply (SELV provided by Limited Power Source incorporating isolating
transformer), rated output:
5 Volt models:
10-30 Volt models:
DC supply voltage is 5 Vdc ±5% for 5 Volt models, 10 to 30 Vdc for 10-30 Volt
models, intended to be powered by a Class 2 power unit with a cable length
< 3m.
Contact the competent authority responsible for the management of radio frequency
devices of your country to verify the eventual necessity of a user license.
Refer to the web site http://europa.eu.int/comm/enterprise/rtte/spectr.htm for further
information.
14
5 V dc, 0.2-5 A
10-20 V dc, 0.2-5 A
N2468
or 20-30 V dc 0.2-3.3 A
STAR Modem™