Star Modem™ Default Configuration; Warranty - Datalogic STAR Modem Guide Rapide

STAR Modem™
UK/US
STAR Modem™ DEFAULT CONFIGURATION
RS232 DEFAULT SETTINGS
9600 baud, parity disabled, 8 data bits, 1 stop bit, handshaking disabled, ACK/NACK
protocol disabled, inter-character delay disabled, 5 sec. rx timeout, FIFO enabled,
frame packing = frame + [CR].
PEN EMULATION DEFAULT SETTINGS
Interpret operating mode, minimum output pulse 600 µs, conversion to Code 39,
overflow medium, output level normal, idle level normal, inter-block delay disabled.
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, num lock unchanged, inter-character and intercode
delay disabled, control character emulation = Ctrl + Shift + Key.
DATA FORMAT
Code identifier disabled, no header, terminator: RS232 = CR-LF; WEDGE = ENTER,
header position = first frame field, code length tx not transmitted, address stamping
disabled, address delimiter disabled.
RADIO PARAMETERS
Transmission mode 1 way, radio protocol timeout 2 sec., single store disabled,
ACK/NACK from remote host disabled, RF baud rate 19200 (European models),
fixed RF baud rate 36800 (USA model), beacon disabled.

WARRANTY

Datalogic warranties this product against defects in workmanship and materials, for a
period of 24 months from the date of shipment, provided that the product is operated
under normal and proper conditions.
Datalogic has the faculty to repair or replace the product, these provisions do not
prolong the original warranty term.
The warranty does not apply to any product that has been subject to misuse,
accidental damage, unauthorized repair or tampering.
12