Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DATALOGIC
The LEDs signal the STAR Modem™ functioning, as described in the following
table:
LED
Power On
Green constant STAR Modem™ is powered.
TX/RX
Yellow blinking
Status
Off
Red constant
Red blinking
INSTALLATION
STAR Modem™ can be installed to operate in different positions by means of two
mounting brackets and an adjustable antenna.
The four screw holes (M4 x 5) on the body of the modem are for mechanical fixture.
See "Antenna", "Mounting Brackets" and "Overall Dimensions" at the end of this
Quick Reference Manual for more details.
SYSTEM CONNECTIONS
CAUTION
STAR Modem™ can be connected to the Host through the dedicated 9-pin female
connector, or by means of an adapter and the Datalogic standard cable
corresponding to the desired interface. In addition, a power supply must be
connected to the power jack provided on the same connector.
See "STAR Modem™ Cable Pinout" at the end of this Quick Reference Manual for
more details.
STAR Modem™ is receiving or transmitting data.
STAR Modem™ is working correctly.
-
at startup, after firmware upload, it indicates that
the system is working with default configuration.
-
during normal functioning it signals a wrong
connection to the Host.
-
it
blinks
execution. In case of wrong command, it will blink
faster.
-
It blinks once when STAR Modem™ radio
transaction fails.
Connections should always be made with power off!
DESCRIPTION
during
a
programming
UK/US
command
3
Publicité
Table des Matières
