Pioneer Elite A-35R Mode D'emploi page 8

PANEL FACILITIES
7
DIRECT button/indicator
Use this button when you do not wish to pass the output from
input terminal equipment through the various frequency
adjusting circuits (BASS, TREBLE, BALANCE, LOUDNESS).
On : The indicator lights: The signals passing through the
input terminals are reproduced without passing through
the various frequency adjusting circuits. This results in
flat, pure sound which is a more faithful reproduction of
the input source.
Off : The indicator goes off: The signal passes through the
various frequency adjusting circuits.
8
SB MODE button/indicator
The SB mode is a special mode in which the amplifier does not
accept remote control (But all of the facilities can be controled
by manual as same as SB mode OFF.). Fix the VOLUME
control near the center position. In this mode, the set can be
used as a power amplifier which amplifies the LINE/SUR-
ROUND BACK input (the function name is LINE/SB) with a
input sensitivity of 1 V.
For example, when the set is combined with one of Pioneer's
Surround Back compatible receiver, the set can be used as
the Surround Back amplifier (For details, please refer to the
instruction manual of the receiver.)
9
TREBLE tone control
Use to adjust the high-frequency tone. The center position is
the flat (normal) position. When turned to the right, high-
frequency tones are emphasized; when turned to the left,
high-frequency tones are de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in
the on position.
8
<ARE7263>
En
0
BASS tone control
Use to adjust the low-frequency tone. The center position is
the flat (normal) position. When turned to the right, low-
frequency tones are emphasized; when turned to the left,
low-frequency tones are de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in
the on position.
-
SPEAKERS B (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to
SPEAKERS B terminals.
ON : The indicator lights. Sound is heard from the speaker
system.
OFF : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening
with headphones.
=
PHONES jack
When using headphones, insert the plug into this jack.
NOTE:
The speakers continue to output sound even when head-
phones are plugged into this jack.
To mute the sound from the speakers, press the SPEAKERS
button to OFF.
~
SPEAKERS A (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to
SPEAKERS A terminals.
ON : The indicator lights. Sound is heard from the speaker
system.
OFF : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening
with headphones.