Technical Data; Before Starting The Equipment - Lux Tools ABS 18 Mode D'emploi D'origine

Anleitung_ABS_18_SPK7:_

5. Technical data

Voltage supply
Idling speed:
Torque settings:
Forward and reverse rotation
Chuck clamping width
Battery charging voltage
Battery charging current
Mains voltage for charger
Charging time:
Battery type:
Weight
Max. screw diameter:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Drilling in concrete
Vibration emission value a
hD
K uncertainty = 1,5 m/s 2
Screwing without hammer action
≤ 2,5 m/s
Vibration emission value a
h
K uncertainty = 1,5 m/s 2
05.01.2011 14:33 Uhr
Additional information for electric power tools
Warning!
18 V d.c.
The specified vibration value was established in
0-350/0-1100 rpm
accordance with a standardized testing method. It
may change according to how the electric equipment
19+1
is used and may exceed the specified value in
yes
exceptional circumstances.
max. 10 mm
The specified vibration value can be used to compare
18 V d.c.
the equipment with other electric power tools.
1.6 A
The specified vibration value can be used for initial
230 V ~ 50 Hz
assessment of a harmful effect.
ca. 1 hour
NiCd/1,3 Ah
Keep the noise emissions and vibrations to a
minimum.
1.8 kg
6 mm
67.33 dB(A)
Residual risks
Even if you use this electric power tool in
3 dB
accordance with instructions, certain residual
78.33 dB(A)
risks cannot be rules out. The following hazards
3 dB
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
2. Damage to hearing if no suitable ear protection is
3. Health damage caused by hand-arm vibrations if
= 5.31 m/s 2

6. Before starting the equipment

2
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack only with the charger
2. Only ever use sharp drill bits and screwdriver bits
3. Always check for concealed electric cables and
Seite 17
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
is used.
used.
the equipment is used over a prolonged period or
is not properly guided and maintained.
supplied.
which are suitable for the purpose and in
faultless condition.
gas and water pipes when drilling and screwing
in walls.
GB
17