Technical Specifications - stayer MULTI DRILL 130 Instructions D'emploi

Extension cords
If an extension cord is necessary, a cord with adequate
size conductors that is capable of carrying the current
necessary for your tool must be used. This will prevent
excessive voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension cords that
have 3-prong plugs and receptacles.
The smaller the gauge number, the heavier the cord.
Recommended sizes of extension cords 120 volt alterna-
ting current tools.
Cord size in A.W.G
Tool´s a,pere
Cord length in feet
rating
25 50 100
3-6 18 16 16
6-8 18 16 14
8-10 18 16 14
10-12 16 16 14
12-16 14 12
Maintenance and service instructions
Before any work on the machine itself, pull the plug.
For safe and proper working, always keep the machine
and ventilation slots clean.
Cleaning
In extreme conditions, always use dust extraction as
far as possible. Blow out ventilation slots frequently
and install a residual current device. When working
metals, conductive dust can settle in the interior of the
power tool. The total insulation of the power tool can be
impaired.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.
Repair service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts.
Exploded views and information on spare parts can also
be found under: info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
Warranty
Warranty card Included in the documentation that
accompanies this equipment, you should find the warranty
card. You should fill out the card completely and return to
vendor with a copy of purchasing receipt or invoice and
you should receive a receipt.
Wire sizes in mm²
Cord length in meter
150 15 30
14 0.75 0.75 1.5
12 0.75 1.0
12 0.75 1.0
12 1.0 2.5
- - - -
ENGLISH
19
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
Disposal and recycling
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
60 120
2.5
2.5 4.0
2.5 4.0
Subject to change without notice.
4.0 -
- -

Technical specifications

These data are valid for nominal voltages of [U] 230/240
V ~ 50/60 Hz - 110/120 V ~ 60 Hz. The values may vary
if the voltage is lower, and in specific versions for certain
countries. Pay attention to the article number on the na-
meplate of your appliance, as the commercial names of
some appliances may vary.
19
Do not dispose of power tools into household
waste! According the European Guideline
2012/19/EC for Waste Electrical and Electronic
Equipment and its implementatio into national
right, power tools that are no longer usable
must be collected separately and disposed of in
an environmentally correct manner.