Ingersoll Rand QC100 Mode D'emploi page 8

EN
Operation Flowchart Admin Setup QC200
...ADMIN MENU...
LAST FAIL: LO FLOW
...ADMIN MENU...
TARGET TORQUE
...ADMIN MENU...
OIL CHANGE CT
...ADMIN MENU...
ADJUST GAIN
...ADMIN MENU...
ADMIN LOCK
...ADMIN MENU...
PGM LOCKOUT OFF
ADMN
PSET LOCKOUT OFF
...ADMIN MENU...
OUTPUTS (LATCH)
...ADMIN MENU...
REHIT
...ADMIN MENU...
FLOW HI LIMIT
...ADMIN MENU...
FLOW LO LIMIT
...ADMIN MENU...
BATCH COUNT
...ADMIN MENU...
BATCH TIMER
EN-7
Set/change your torque, you would like to achieve (this does not
SELECT TARGET TQ
provide torque control).
TQ: 13.00
Goes from 0.999,999 cycles, measures number of cycles until next
0/115200
oil change.
UP/CLR DOWN/SET
Use UP/DOWN arrows to set GAIN between 1-9 (scale).
SET GAIN
GAIN = 9
Enter a four digit code you will be asked to enter this code to access
LEARN ADMIN CODE
CODE : **** the Admin menu in the future.
Enable or disable access to change program setting.
...ADMIN MENU...
PGM LOCKOUT ON
Enable or disable access to select between two set programs.
...ADMIN MENU...
PSET LOCKOUT ON
If Selected LATCH: Status signals do not change till next tool start,
...ADMIN MENU...
OUTPUTS (MOMENT)
If Selected MOMENT: Status signal stays for moment then goes OFF.
While in this screen, rehit a fastener and a flow number will appear
ADJUST REHIT
on the left. If you want to turn rehit off, enter zero for NEW, if you
97 NEW: 0
want to make sure that you catch all rehits, enter a number that is
higher than any of the sample rehits that you tried.
HI LIMIT: 4095
Goes from 0 to 5000. Required when there is need to detect air
FLOW: 49396 READY
leakage in vent. Compares displayed values at Q-Box for flow, adjust
limit that prevents error signal and achieves required torque (Not
CFM value, just a scale).
LO LIMIT: 4095
FLOW: 49396 READY
Change the number of fasteners per batch.
SET BATCH COUNT
0-99.
COUNT: 10
Batch timer goes from 0 to 999 seconds. This is the maximum
SET BATCH TIMER
allowed time from end of first cycle to end of last cycle.
TIME: 154
45498318_ed1