Ingersoll Rand QC100 Mode D'emploi page 4

EN
Initial Setup for QC100
(Use with non shut-off pulse tool or impact wrenches)
QC100
Date Time
SETTING ZERO
PLEASE WAIT
PARAMETER SET 1
NOT SETUP
SET TARGET TQ
TQ:18.0
REHIT FASTENER
RUN TOOL
REHIT FASTENER
RUN COMPLETE
SETTING ZERO
PLEASE WAIT
REHIT FASTENER
RUN TOOL
REHIT FASTENER
RUN COMPLETE
SETTING ZERO
PLEASE WAIT
LEARN JOINT
RUN TOOL
LEARN JOINT
COMPLETE
RUN FREESPEED
RUN TOOL
RUN FREESPEED
COMPLETE
SET BATCH COUNT
COUNT: 3
SET BATCH TIMER
TIME: 010
SHUT-OFF VALVE?
UP/YES DOWN/NO
TQ: 18.0 PS: 1
CT: 03 TIMER: 010
EN-3
Press and hold the "ENTER & GO BACK", then
switch the power supply OFF and then ON.
This will reset the qualifier.
Select Parameter 2 by using the UP Arrow.
Press UP/DOWN arrow to set the TARGET TORQUE.
This value is for reference only. The qualifier is not a torque control
or measurement device.
Engage the tool on a fastener that has already been tightened to
the desired torque and run until "RUN COMPLETE" appears.
Stop tool as soon as this message is displayed.
Run Tool on an actual fastener.
When complete, ensure proper torque was acheived.
Run tool freespeed (without fasteners) until "COMPLETE" appears.
Set batch count = 0, if batch counting is not required.
No. of fasteners to be tightened in one batch (Ex: one engine unit
with 8 bolts; count = 8). If a click wrench is used (with input signal
to I/O terminal no. 5) to verify each fastened bolt, then count =16.
Expected total time in seconds required to complete above set
batch (Duration is the time elapsed between end of the first cycle
and the end of the last cycle).
If all cycles in a batch are not completed in this time, Batch NOK
will be returned.
When shut-off valve is installed, choose YES. You can change the
cycle delay in the ADMIN menu, the default is 50 (50 counts is
approx 0.5 sec).
Setup complete, Ready to work.
Q BOX
CLEAR COMPLETE
This button is referred to as
the ENTER button. Use this
button to select an option
and to move to the next
screen.
This button is referred to as
the GO BACK button. At any
screen you may use this to go
to the last step.
REHIT: Tool running on a fastener that
has already been torqued.
45498318_ed1