ZIBRO CLIMA TIN-327W Manuel D'utilisation page 51

Room temperature:
< 0 °C
0 - 5 °C
5 - 10 °C
> 10 °C
Comments relating to the use of the 'DEHUMIDIFY" function
• The ventilator speed can not be adjusted when using this function.
• In this setting, the ventilators in the interior and exterior sections do not
operate continuously.
• This function can not be used at a room temperature of 13 °C or lower.
F
ADJUSTING VENTILATOR SPEED AND AIRFLOW DIRECTION
The ventilator speed adjusts automatically according to the room temperature.
Adjusting the ventilator speed
Ventilator setting:
LOW
MEDIUM
HIGH
You can change the air flow by pressing the 'Ventilator speed' button - the speed
will change each time you press the button (see above).
Setting the direction of the air flow
- Only adjust the air flow up or down with the remote control.
- Adjust the air flow to the left or right manually before activating the device.
ATTENTION!
The remote control can be used to adjust the vertical air flow for the following
functions:
- COOLING and DEHUMIDIFYING, when the airconditioner has been in
operation for 1 hour with the air flow directed downwards, the air flow
will automatically be adjusted to a position that ensures that no
condensation can drip out.
- During heating or defrosting, the horizontal blades are set to direct the air
flow upwards in order to ensure that you are not annoyed by cold air.
- Select the maximum ventilator speed to ensure that the entire room reaches
the desired temperature with the minimum of delay.
Unit starts operating:
50 min. Before set time
40 min. Before set time
30 min. Before set time
20 min. Before set time
Power air flow:
Gentle air flow
Medium air flow
Powerful air flow
4
51