Installing The Belt Hook; Cold Weather Operation - DeWalt DWFP1838 Guide D'utilisation

Depth Setting (Fig. 1)
WARNING: Disconnect air line from tool and remove fasteners
from magazine before making adjustments or personal injury may
result.
The fastener depth control adjustment feature provides control
of the fastener drive depth from flush with or just above the work
surface to shallow or deep countersink.
Rotate depth control adjustment wheel (K) to give the desired depth
of drive.
Belt Hook (Fig. 1, 5)
The belt hook (J) can be changed to either side of the tool to
accommodate left- or right-handed users.

INSTALLING THE BELT HOOK

WARNING: Disconnect air line from tool and remove fasteners
from magazine before making adjustments or before attempting any
assembly or disassembly.
WARNING: Always remove the belt hook from the tool when
selecting Contact Trip Mode.
1. Assure that the sequential trip mode is selected.
2. Squeeze the sides of the belt hook body.
FIG. 5
J
3. Align the post on the belt hook body with the alignment hole and
push into position.
4. Release the sides of the belt hook body and check to ensure that
the belt hook is locked in position
Using The Integrated Pencil Sharpener
(Fig. 6)
A standard pencil sharpener (C) is integrated into the belt hook for
the operator's convenience. To sharpen a pencil, insert any standard
pencil into the hole and rotate the pencil to the right (clockwise)to
sharpen.
FIG. 6
C

Cold Weather Operation

WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the stapler pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the stapler.
When operating tools at temperatures below freezing, complete
preparation procedures outlined above and follow the directions
below.
9