Bosch TCA 53 Série Notice D'utilisation page 23

Masquer les pouces Voir aussi pour TCA 53 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
en
Starting the service programme
The appliance must be ready for use.
● Empty and replace the trays 17 and 18.
● Press and hold the buttons 4
for at least 5 seconds.
S
The
LED starts to flash and the appliance
rinses the coffee dispenser through twice.
● Empty and reinsert the grounds tray 17.
The LEDs for button
light up.
● Place one cleaning tablet in the duct 13.
● Fill the water tank with lukewarm water,
add descaling agent and dissolve com­
pletely (total liquid 0,5 litres)
or
pour prepared descaling mixture into the
water tank (total liquid 0,5 litres).
● Press the steam button
process begins. Duration approx. 10 min­
utes. The descaling solution flows into the
water tray 18.
J
The
LED lights up.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Set the dial 6 to
process begins. Duration approx. 5 min­
utes. The descaling solution flows into the
container.
I
The
LED lights up.
● Empty and reinsert the grounds tray 17.
The steam button LED
● Empty and clean the water tank 11, fill
with fresh water up to the "max" mark and
reinsert.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Press the steam button
ing process begins. Water flows into the
container.
F
and 5
h
H
and
"Add water"
h
. The descaling
g
h
/
. The descaling
h
lights up.
h
. The clean­
J
The
LED flashes.
● Turn the dial 6 to "O". The cleaning proc­
ess begins. Duration approx. 10 minutes.
h
Liquid flows into the coffee grounds tray
17 inside the appliance, then out through
the coffee outlet.
I
The
LED lights up.
● Empty, clean and reinsert the trays 17
and 18.
The appliance starts to heat up and is
ready for use once the LEDs for dispensing
E
buttons 3
Important: If the service programme is
interrupted, e.g. due to a power cut, it is
vital that the appliance be rinsed before it is
used again.
The appliance must be ready for use.
â
The
and steam button
● Rinse the water tank 11 thoroughly and fill
with fresh water.
● Press the steam button
is rinsed and liquid flows into the tray.
J
The
LED lights up.
● Hold a cup under the nozzle 8 and turn
the dial 6 to
cup.
J
The
LED flashes.
● Turn the dial 6 back to "O".
The appliance rinses and is ready for use
again.
F
and 4
light up.
h
LEDs flash.
h
. The appliance
g
h
/
. Water runs into the
19
TCA53 03/2012

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tca5309

Table des Matières