Olimpia splendid B0152 Mode D'emploi page 29

KEYS FUNCTIONS (fig. 7)
SWITCHING ON THE REGULATOR
Once you have connected and powered the device, press the RESET button for 2-3 seconds with the
tip of a pencil. All the segments and symbols available will appear on the display for a few
seconds (AUTOTEST). After that the regulator gets switched off, in heating mode. See the paragraphs
below to perform the required settings.
SETTING THE TEMPERATURE
Use keys T+ and T- to set the desired temperature, displayed at the bottom right.
MANUAL SETTING OF THE FAN SPEED
Use keys V+ and V- to set the desired fan speed.
AUTOMATIC FAN OPERATION
Press key A/M to start automatic operation of the fan. The speed will be proportional to the difference
between the desired temperature and the one actually measured (higher the difference -> the greater
the speed). Press key A/M once again to go back to the manual operating mode of the fan.
DEVICE RESET
Press the RESET key to perform an AUTOTEST of the system and return to the normal operating mode.
The values set will not be lost (fig. 8).