Installation And Connections; Safety Requirements - Olimpia splendid B0152 Mode D'emploi

INSTALLATION AND CONNECTIONS

SAFETY REQUIREMENTS

Before connecting the regulator to the system make sure that the mains voltage IS NOT CONNECTED
and that it corresponds to the voltage indicated on the back of the regulator (230V~ /50Hz).
POSITIONING
The position of the thermostat may significantly affect its performance. Install the device on the inner
wall of a room in which you usually stay, away from draughts (doors, windows, fans, etc.), sources of
heat (radiators, sun's rays, kitchens, household appliances such as televisions, refrigerators, computers,
etc.) and vibrations, about 1.5 m from the floor ensuring regular air flow, if necessary sealing the
outlet tube of the connection cables (fig. 2).
INSTALLATION
The regulator is already mounted inside its housing and fastened to the appropriate standard SUPPORT
FRAME, so only the following installation operations are required:
• Perform the connections as described in the paragraph below "Electrical wirings".
• House the Regulator with its SUPPORT FRAME (fig.3B) in the 3-module box previously embedded
into the wall (fig.3C) and fasten it with the screws supplied.
• Pressure mount the desired PLATE (Fig.3A).