Hitachi Koki DS 14DBL Instructions De Sécurité Et Mode D'emploi page 18

English
Use
Machine
screw
Driving
Wood screw
Wood
Drilling
Metal
10. About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
(Fig. 12) When releasing your finger from the
remaining battery indicator switch, the remaining
battery indicator lamp goes off. The Table 7 shows
the state of remaining battery indicator lamp and
the battery remaining power.
State of lamp Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows
somewhat differently depending on ambient
temperature and battery characteristics, read it as
a reference.
NOTE:
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
11. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
18
Clutch Position
For 4 mm or smaller diameter
1 – 22
screws.
For 8 mm or smaller nominal
1 –
diameter screws.
For 65 mm or smaller
diameters. (DS18DBL)
For 50 mm or smaller
diameters. (DS14DBL)
For drilling with a metal
working drill bit.
Table 7
Table 6
Rotating speed selection (Position of the shift knob)
LOW (Low speed)
●
When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
●
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 12)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 13)
Hook
HIGH (High speed)
For 6 mm or smaller
diameter screws.
For 4.8 mm or smaller
nominal diameter screws.
For 24 mm or smaller
diameters.
Screw
Hook
Fig. 12
Groove
Screw
Fig. 13