Cherry MW 8 ERGO Guide Rapide page 10

64410045-01_DE-EN-FR-ES-IT-NL-SV-NO-DK-FI-PL-CS-SK_KA-MW8Ergo.fm Seite 10 Donnerstag, 18. J
and another PC/laptop. Switch off this PC/laptop
or deactivate the connection on this PC/laptop.
5 Follow the instructions in the software.
If the red LED of the mouse flashes quickly, the
connection has failed.
• Try to establish the connection again.
3 Connecting the mouse via the
receiver
The receiver is in a compartment on the bottom of
the mouse and is held in place by magnets.
1 Pull the receiver out of the housing.
2 Connect the receiver to the USB socket on the
PC/laptop.
3 Set the switch on the bottom of the mouse to
"RF".
4 Adjusting the sensitivity of the
mouse (DPI number)
• Press the DPI button on the top of the mouse.
The LED flashes depending on the setting:
1x = 600 dpi
2x = 1000 dpi
3x = 1600 dpi
4x = 3200 dpi
10
5 Charging the mouse
Battery charge status
The battery in the mouse is already
charged. You can use the mouse
immediately.
• Before first use, however, we recommend that
you charge the mouse fully with the cable
supplied.
When the red LED flashes, you should charge the
mouse soon.
• Connect the charging cable to the mouse and a
USB socket on the PC/laptop.
6 Disposal
This device contains a lithium ion battery.
This cannot be replaced.
Do not dispose of the device in the house-
hold waste. Batteries may contain pollut-
ants which can harm the environment and health.
Dispose of the battery with the device in a retail out-
let or at your local recycling depot. Returning the
device is compulsory and free of charge.