Safety Instructions Relating Specifically To The Equipment - MeisterCraft MPS 800 EL Traduction Du Manuel D'utilisation Original

5453380-Pendelhub-man 06.02.14 07:48 Seite 34
6 – Safety instructions
relating specifically to
the equipment
• Use only sharp, undamaged saw
blades. Torn, bent or blunt blades
should be replaced immediately.
• Match the tool insert, stroke rate and
pendulum action to the material in
question. Pay attention to an even feed.
• The unit may only be operated with
the footplate mounted. When
working, the footplate should always
rest against the work piece.
• Always start the unit before
introducing it to the work piece.
• Do not process materials that contain
asbestos. When processing other
materials that contain fibres, use a
face mask and dust extraction unit.
• If the device is to be used outside, it
must be connected via a residual
current circuit-breaker. Extension
cords and plugs must be certified for
outdoor use.
• Do not attempt to stop the saw blade
by applying pressure to the sides.
• Secure the work piece to prevent it
from slipping by using tensioning
mechanisms.
• Make sure that cables always lead
away from the work place.
• During operation, always guide the
device with both hands and ensure
that you are standing firmly.
• The device should never be allowed
to get wet and should not be
34
operated in a damp environment.
• Prior to each use, check the device,
the cable and the plug. Any damages
should only be repaired by a
specialist. Only plug the device
into the socket when the machine is
switched off.
• When carrying out work in which dust
is generated, wear a face mask and
safety goggles - do not smoke and
avoid naked flames.
• When handling saw blades and rough
materials, wear gloves.
• When changing a saw blade, wear
protective gloves to prevent injuries
caused by the sharp cutting edges of
the blade.
• Wear ear-protectors.
• Wear safety goggles.
• Before carrying out any work on the
machine, pull the plug out of the
socket.
• Do not leave keys in the machine.
• Observe the general safety notes for
handling electrical tools.