Kenwood KCA-CM50 Mode D'emploi page 16

Installation
■
Installation of Controller unit
• Installation without using the trim mount plate
Controller unit
1
• Installation using the trim mount plate
Pass the wire from the controller unit through the hole on
the trim mount plate and push fit the controller unit into
the trim mount plate until it locks.
2CAUTION
• Be sure not to place the unit on such place as where it is
exposed to direct sunlight and temperature eventually rises.
It results in the deformation of the case.
• Depending on the installing location, the controller unit may
not be able to receive the signals from the remote controller
unit (Option). Install them after confirming that the signals
can be received.
• Install the unit in such a way that it does not disturb driving.
3
Attach one strip of Velcro to the
slanted-line of the controller
units as shown to the left, and
attach the other strip of Velcro
to the parts where you wish to
attach the controller units.
Then, put velcros together and
install the controller units.
3
Controller unit
3
■
Installation of Power cable
Power cable
— 16 —
2
Carpet