Connecting Wires To Terminals - Kenwood KCA-CM50 Mode D'emploi

Connecting Wires to Terminals

Car Audio unit
Audio input
Audio output
(Left: White, Right: Red)
Power cable input
(Front side)
(Rear side)
If no connections are made,
do not let the wire come out
from the tab. 18a
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
2WARNING
To prevent fire when the ignition wire (Red) or
battery wire (Yellow) is short-circuited by coming
into contact with the vehicle chassis (ground), only
connect the power supply after making the fuse
box connections.
2CAUTION
Be sure to press the reset button after installation.
SIRIUS Satellite Radio tuner /
HD Radio tuner
Power cable
ANT CONT
Ignition wire
Battery wire
Ground wire (Black)
— 15 —
Controller unit
Antenna input
Controller unit input
Not Used
When you connect the controller unit
to SIRIUS satellite radio tuner, don't
connect this wire.
+
(Red)
ACC
+ Car fuse box
(Yellow)
BATT
-
(To car chassis)
ACC Ignition key
switch
Battery