Dometic GROUP WAECO PerfectView M5L Instructions De Montage page 30

_M5L_M7L_M7LX.book Seite 30 Montag, 7. Mai 2012 10:59 10
Mounting the LCD monitor
Choosing the installation location
➤
Place the monitor and the mounting rail on the monitor bracket (fig. a A, page 6).
➤
Place the monitor bracket and the mounting rail onto the support base and secure it
using the knurled nuts (fig. a B, page 6).
➤
Position the monitor and the attached monitor bracket provisionally.
➤
Mark the outlines of the corners of the support base on the dashboard.
➤
Unscrew the support base from the monitor holder.
NOTE
I
You can fasten the support base using adhesive or screws.
Sticking the monitor bracket onto the dashboard (fig. b A, page 6)
➤
Remove the film from under the support base.
➤ Stick the support base to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig. b B, page 6)
➤
Hold the support base within the outlines marked beforehand.
➤ Mark four different drilling points.
Drill a hole of  2 mm at each of the points marked beforehand.
➤
➤
Screw the support base on using 4 x 20 mm self-tapping screws.
Fastening the monitor
➤
Place the monitor and the mounting rail onto the support base and secure it using the
knurled nuts (fig. a, page 6).
30
PerfectView M5L, M7L, M7LX
EN