Mounting The Lcd Monitor; Installing The Monitor - Dometic GROUP WAECO PerfectView M5L Instructions De Montage

_M5L_M7L_M7LX.book Seite 29 Montag, 7. Mai 2012 10:59 10
PerfectView M5L, M7L, M7LX
7

Mounting the LCD monitor

7.1 Tools required (fig. 1, page 2)
For installation and assembly you will require the following tools:
 Measuring ruler (4)
Centre punch (5)

 Hammer (6)
 Drill bit set (7)
 Drill (8)
 Screwdriver (9)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (1) or voltmeter (2)
 Insulating tape (10)
 Heat shrinking sleeve
 Hot air blower (11)
Crimping tool (12)

 Soldering iron, if required (13)
Solder, if required (14)

 Cable bushing sleeves, if necessary
To fasten the cables, you may require additional cable binders.
7.2

Installing the monitor

CAUTION! Risk of injury!
!
Select the location of the monitor so that it cannot injure anybody in the vehicle
under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
 Select an installation location that provides an unobstructed view of the monitor
(fig. 6, page 3 and fig. 7, page 3).
Never install the monitor in areas where your head may impact or in the area that would

be filled by an expanding airbag. This could cause injury if the airbag opens.
The monitor may not impair your vision when driving (fig. 8, page 4).

 The installation location should be flat.
Check that there is sufficient room underneath the installation location to attach the

washers and nuts.
 Check beforehand that there is sufficient room for the drill head to come out on the
other side (fig. 2, page 3).
 Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
 Ensure that you can lay the connection cables to the monitor.
EN
Mounting the LCD monitor
29