Ayce PN3800 Notice Originale page 77

Figure BB.106-Log supported both ends
Figure BB.107-Bucking a log
Stopping the engine
1. Reduce the engine speed and let it run with no load for a few minutes.
2. Switch off the engine by moving the engine switch to the stop position.
The accessory may cause an accident if it continues to turn after the engine has stopped or after
the engine switch has been released. When the unit has stopped, check carefully that the accessory
has stopped turning before putting the unit down.
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation. It will also help reduce
air pollution.
The purpose of the maintenance and adjustment schedule is to keep the machine in the best
operating condition.
Turn off the engine before performing any maintenance. If the engine must be run, make sure the
area is well ventilated. The exhaust contains poisonous carbon monoxide gas
Please always select recommended accessories. The accessories which have not equivalent
quality may damage the machine.
Please never use non approved components and remove the safety devices after or during
maintenance.
Maintenance
Clean the outside of the machine.
Check that the engine switch works correctly.
Check that the saw chain do not move when
the engine is idling or when the choke is in the
start throttle position.
Check that the saw chain are undamaged and
show no signs of cracking or other damage.
Replace the saw chain if necessary.
Clean the air filter. Replace if necessary.
Check that nuts and screws are tight.
Check that there are no fuel leaks from the
engine, tank or fuel lines.
152 153
Daily Weekly Monthly
maintenance maintenance maintenance
X
X
X
X
X
X
X
GB