CDVI PCV123D Manuel D'installation page 13

INSTALLATION MANUAL
PCV123D (DGM1D)
Desktop and Handheld Mifare
In case of loss of the access code and/or password of your controller
If during a connection with a PCV123D terminal unit, you type a wrong code site and/or
password, the display PCV123D: «CODE SITE PASSWORD or wrong» followed by a decryption
chain (decryption chain appears only if you communicate with the RS232). This decryption
chain contains the site code number and password of your central DGM1D. Contact this
decryption chain of your controller to the dealer. Then he will provide you the site code and
password of your plant.
Once in possession of the site code and password, enter the site code, then enter the
password, then you have access to your DGM1D controller.
For more information, please contact your dealer.
3] PCV123D TERMINAL UNIT MENUS
The PCV123D terminal unit manages and programs DGM1D controller + reader
Press ON, the terminal unit displays: «Terminal Version x.x ».
To enter in the menu press on the
PCV123D terminal unit is connected to the DGM1D controller (RS232 or RF), or to the PC
software via the RS232 on the PC. Enter the site code of the controller and then the password:
- Confi guration,
- Cardholders.
Note: The terminal unit switchs off after 5 minutes of inactivity.
SWITCH ON THE TERMINAL UNIT
(PRESS ANY KEY)
CONNECT TO CONTROLLER
MENU 1
(ADMINISTRATION DGM1D)

Enter site code

DGM1D Controller
Detected
terminal
®
key or key of the keypad. Make sure that the

Enter password

A ] CONFIGURATION
B ] CARDHOLDERS

Connection to the
controller
cdvigroup.com
EN
cdvi.com
13