Greencut TDC600C Manuel D'utilisation page 55

3. Place drill head (4) in column (2) so that the shaft is aligned with the center hole of the base. Make sure that
the drill head is completely aligned down the column, then secure it by tightening the screws (c) with the
Allen wrench supplied.
4. Screw the handles (A) firmly into the threaded holes in the hub (B).
5. Push the chuck toward the top of the shaft tip to
the maximum. It is recommended to push the chuck
quickly up on the shaft. The friction between the
shaft and the hole in the chuck should be sufficient
to hold the chuck in place.
6. Turn the outside of the chuck to the left
(counterclockwise) viewed from above and open the
chuck jaws completely.
7. Place a flat piece of wood on the table and use the
crank to lower the chuck against the wood. Press
the chuck firmly to lock the chuck shaft heads.
4
c
4
B
B
A
A
5
H
55
EN