Cleaning And Maintenance; Poblems And Solutions; Technical Data - Domo DO42440KM Mode D'emploi

CLEANING AND MAINTENANCE

1. Always pull the plug out of the socket before cleaning the appliance. Do not clean the appliance
under running water. Never immerse the base and reservoir in water.
2. Wipe the housing down with a damp cloth and dry the appliance. Nothing from the appliance don´t
wash in dishwasher.
3. Not regular and correct maintenance of the appliance can cause worse grinding results or can cause
even damage of the grinder.
4. Remove excess ground coffee from the grinder chute with a small brush.
5. Coffee beans are oil. Clean all containers only with dry paper towel.
6. Don´t clean with abrassive cleaner.
Cleaningthe upper burr disk
1. Set the fineness selector dial to the finest grind setting.
2. Grasp the top of the upper burr disk, turn clockwise until loose and then pull upward vertically to
remove it from the bean container.
3. Lift the upper burr disk out of the grinder.
Note: Do not unscrew the upper burr from its housing!
4. Clean both the removable upper burr disk, and the permanent lower burr disk with a brush.
Note: Never use water to clean the burr disks!
5. To reinsert the upper burr disk, set the fineness selector dial to the coarse grind setting. Insert the
upper burr and turn counterclockwise until it is locked into place.
Note: Be careful not to tear the upper part of the grinding unit when loosening it.
! Warning: never clean the grinding unit with water and do not wash in the dishwasher!

Poblems and solutions

1. The grinder does not work when On/Off button is pushed
• Make sure that the plug is inserted correctly into a working outlet.
• Ensure the lid of the bean container is properly placed onto the housing.
• Check that the ground coffee container and its lid are placed correctly into the base.
2. The grinder stops during operation
• The grinder is overheated. The resettable thermostat of the motor was activated. To reset the
thermostat, allow the appliance to cool down for approximately 30 minutes. To avoid overheating,
do not exceed the MAX indications of the ground coffee container.
• A removable part has become dislodged. Check that the coffee bean container lid and the ground
coffee container and its lid are correctly placed into the housing of the machine.
3. Grinder clogs easily
• Unplug the unit and ensure the grinder chute is clear of any clogs. Clean the grinder chute often.
• Try a new type of coffee bean. Do not use flavored or coated beans.
• If you are using oily beans, try a coarser grind setting.
4. The fineness selector does not work
• Check if the upper burr disk is correctly positioned in the bean container (see chapter
"Cleaning/Removing the Upper Burr Disk"

Technical data:


Rated voltage: 220-240 V~ 50-60 Hz

Power consumption: 130 W

Protection class: II