Before The First Use - Domo DO42440KM Mode D'emploi

PARTS
1. Coffee bean container lid
2. Upper burr (removable)
3. On/Off button
4. Bean container
5. Cup selector dial
6. Fineness selector
7. Grinder chute
8. Base
9. Ground coffee container lid
10. Ground coffee container

BEFORE THE FIRST USE


Remove all packaging materials and any promotional stickers before using for the first time.

Clean the coffee grinder before use. See 'Cleaning and maintenance' section.

IMPORTANT: Grinder was tested with beans during assembly. Despite cleaning, traces of ground
coffee may be found in a new machine.
USE - ASSEMBLY
1. Place the device on a firm, dry, even surface.
2. Ensure all parts are locked into place. There is safety switch what doesn´t allow to switch grinder on
when parts are not properly in place.
Note: Never use wet accessories.
3. Open the lid and fill the bean container with coffee beans and replace the lid.
Note: There is the safety fuse what doesn´t allow to switch grinder on without lid.
Note: Never fill water or any other liquid into the bean container.
4. Plug the grinder into an outlet.
5. Set the fineness selector to the desired setting . The fineness selector knob has 15 different settings to
control the size of the ground coffee. The smallest dot corresponds to the finest setting and the
largest dot corresponds to the coarsest setting. Never change the fineness selector setting while
grinding!
6. Set the cup selector dial to the number of cups of coffee you want to grind by turning the dial to the
number of cups you will brew.
Note: These numbers are to be used as a guide. The amount of ground coffee varies quite a bit
depending on how coarse or fine you grind and whether you use light, dry beans or dark, oily beans.
After grinding a few times, you will find the correct grind amount position for the amount of coffee
you want to grind.
7. Push the On/Off button down to start your grinder. The grinder will begin grinding the whole bean