Receiver Installation; Changing Batteries - BST UDR 66 Manuel D'utilisation

UDR 66

RECEIVER INSTALLATION

CHANGING BATTERIES

OPERATING OF TRANSMITTER
© Copyright LOTRONIC 2012
Clip the receiver to a belt For best results, slide the receiveruntil the beltispressedagainst the base of the
clip.Thenconnect the earphoneprovidedwith the set on the earphone socket
Expected life for twoAlkaline batteries are approximately 5 hours.
When the LCD panel batterysignisflashing(seebelow), the batteries shouldbechangedimmediately, as
shown on the left.
9) ANTENNA
10) RF SIGNAL LED
The RF signal ledlight's on when the
wirelessconnectionbetweentransmitter and receiveris on. If the
ledstays off, check :
- The frequencies of transmitter and receiver are same
- The transmitteris on
- The batteries of receiver are good
11) EARPHONE SOCKET
Connect on this socket the earphoneprovidedwith the set
12) LEVEL CONTROL AND ON-OFF SWITCH
This control isused to increase or decrease volume level on earphone
and use italso to switch the receiver on or off
13) DISPLAY
See description later
14) DOWN BUTTON
See description later
15) SET BUTTON
See description later
16) UP BUTTON
See description later
WWW.BSTDJ.COM
Page 9