Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The battery does
not engage with
an audible "double
click".
The drive spindle
does not rotate.
Product switches off
automatically.
Product switches off
if drill bit jams.
The combihammer
or the battery gets
very hot.
No response from
the LEDs on the bat-
tery.
16
English
Possible cause
The retaining lugs on the
battery are dirty.
The permissible operat-
ing temperature of the
product's electronics
has been exceeded.
Battery is discharged.
The overload protection
system is active.
The electronic safety
shut-down has tripped
to avoid further jam-
ming.
Electrical fault.
The product is over-
loaded (application limit
exceeded).
The battery is not fully
inserted.
Battery is discharged.
The battery is too hot or
too cold.
Action to be taken
▶ Clean the retaining
lugs and refit the
battery.
The ON/OFF indicator
flashes.
▶ Allow the product to
cool down.
▶ Change the battery
and charge the empty
battery.
The ON/OFF indicator
flashes.
▶ Release the control
switch. Allow the
product to cool down.
Press the control
switch again. Reduce
the load on the tool.
▶ Release the drill bit.
▶ Immediately switch off
the product. Remove
the battery and keep
it under observation.
Allow it to cool down.
Contact Hilti service.
▶ Select a product that
is suitable for the
intended purpose.
▶ Push the battery in
until it engages with a
double click.
▶ Change the battery
and charge the empty
battery.
▶ Bring the battery to
the recommended
working temperature.
2201899
*2201899*
Publicité
Table des Matières
