DUROFIX RM602-3 Manuel Informations Du Produit page 8

BATTERY INSTALL AND REPLACEMENT
1. Prepare 2 new coin cells of "CR2032".
2. Loosen the 2 screws on the coin cell cover by a screwdriver.
3. Replace the 2 coin cells (with the "+"sign facing upwards).
4. Tighten the screws to fix the cover.
NOTE
1. When cell capacity is low, the digits on the display will be not clear.
2. Remove the coin cells if stored for a long period of time.
3. Keep spare coin cells on hand when going on a long trip or to cold areas.
4. Do not mix the type of coin cells or combine used coin cells with new ones.
5. Sweat, oil and water can prevent a coin cell's terminal from making electrical contact. To avoid this,
wipe both terminals before loading a coin cell.
6. Coin cell life depends on coin cell quality and the amount of buzzer is used.
7. Dispose of coin cells in a designated disposal area. Do not throw coin cells into a fire.
WARNING
Always remove battery pack before changing accessories or making adjustments.
POWER ON
Press and release the Power Button (3) to turn the adapter on.
ZERO FUNCTION
When powers on, the digital torque tool can be zeroed at measure mode by press and
release the Power Button (3).
NOTE
Do not zero at the torque is applying on the digital torque tool.
HOW TO SET PEAK MODE OR TRACE MODE
Press and release the Down Button (4) or Up Button (5) to select the mode you need.
TRACE MODE: When in track mode the adapter will display real-time torque.
PEAK MODE: When in peak mode the adapter will hold the highest measured
reading on the display until "zero-clear" by pressing and releasing the Power button (3).
1English1
ASSEMBLY
OPERATION
To reduce the risk of injury, wear safety goggles or glasses with side shields.
English -7