DUROFIX RM602-3 Manuel Informations Du Produit page 4

1English1
Use personal safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal
injuries.
Do not over reach. Keep proper footing and balance at all times. This enables better control of the
power tool in unexpected situations.
Do not expose digital torque tools to rain or wet conditions. Water entering a digital torque tool will
increase the risk of electric shock.
Ratchet mechanism may slip of break if dirty, mismatched or worn parts are used, or direction lever
is not fully engaged. Ratchets that slip or break can cause injury.
Always pull-do not push- on the wrench handle and adjust your stance to prevent a possible fall
while applying torque.
POWER TOOL USE AND CARE
CAUTION
For hand use only.
Do not apply excessive torque or force to the tool housing. The torque only applies on the driver head.
Do not shake or shock.
Never use this digital torque tool to loosen fasteners.
This digital torque tool is for hand use only.
Always verify that the digital torque tool capacity matches or exceeds each application before
proceeding.
Always verify the calibration of the digital torque tool if you know or suspect its capacity has been
exceeded. To ensure accurate measurement periodic recalibration is necessary.
Never force the head of flex head drive against stops.
Keep this digital torque tool away from magnets.
Do not apply excessive force to the LCD panel.
Use the digital torque tool only for the intended use described in this manual. Do not use this digital
torque tool as a hammer.
Do not use the digital torque tool if it is not working properly, or if it has suffered any damage.
Be sure all components, including adapters, extensions, drivers and sockets are rated to match or
exceed the torque being applied with tool.
Do not disassemble the digital torque tool.
Observe all equipment, system and manufacturer's warnings, cautions and procedures when using
this digital torque tool.
Always using the correct size socket for the fastener being torqued.
Do not use damaged sockets, showing signs of wear or cracks.
Do not apply torque exceeding the rated capacity, regardless of whether the digital torque tool is On
or Off. Avoid shock load. Over-torque (120 % of Max. torque range) could cause breakage or lose
accuracy.
Never operate digital torque tool when powered OFF. Always power digital torque tool ON prior to
applying torque.
Do not press ON/ZERO button while torque is being applied.
English -3