Programming Mode - Menu For Service Techs - Conti 400 Manuel D'utilisation

RESET SHOT COUNTER FOR SINGLE & DOUBLE SHOTS
While reading the number of shots produced for 1 and/or 2 cups, you may reset these two counters by
simply pushing simultaneously both keys T2 and T3 until display illustrates "RESET COUNTER"
(See Figure 8). The grinder will then return to Stand-by mode again.
Ex. Single cup
Display shows:
NOTE: Both shot counters for 1 and 2 cups will be reset at the same time.
14. PROGRAMMING MODE – MENU FOR SERVICE TECHS
In this section you can select and set the language, the counter for the life span of grinding discs and the
"Time Lag".
ADJUST ILLUMINATION LCD
To access the TECHNICAL MENU, switch off the grinder. Push and hold both keys T1 and T2
simultaneously while switching on grinder again - hold both keys for approx. 10 sec. (see figure 9) until
display shows
> PLEASE ADJUST ILLUMINATION LCD <
Ex.: Display shows :
Push (T2) to increase or (T3) to decrease the contrast of the display and characters shown. Push (T1) to
confirm selected contrast and to continue with other settings, if applicable or push (T4) to save and exit
the Menu and to return to Stand-by mode again.
SACOME, Document CONFIDENTIEL,
Figure 8
Figure 9
Edition 04/2017 - CG400
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 26 -