Warning - Installation Instructions And User Restrictions - Conti 400 Manuel D'utilisation

10. WARNING - INSTALLATION INSTRUCTIONS AND USER RESTRICTIONS

WARNING
Before installation and using the device, please read carefully the user manual.
POWER- ON
Before turning-on the device, please perform all the necessary connections according to local regulations
in place. Some components are connected to the power supply. Before doing any maintenance, always
unplug power cord from mains supply.
•
The non-observance of it may cause death risk. Please make sure that there is no accidental
connection.
•
Please make sure that the power supply to which the device is connected is in conformity
with the label's data (nominal values) before connecting it.
•
The installation of the device must be performed by an authorised service provider or certified
electrician only.
•
In case of any risks and danger concerning safety, please replace complete unit.
PROTECTION
Please make sure that all the accessible metallic parts, which can become live in the event of insulation
fault, are firmly connected to the ground terminal of the grinder.
Also, please make sure that the machine's ground terminal is connected properly to the housing and to
the mains supply.
EXTERNAL COMPONENTS
The components on the board that are necessary to reduce the electric interference, must not create
any impact on the safety and proper functioning of the grinder.
COMPONENTS
In case of necessity, we reserve the right to substitute electronic parts with alternative components,
having the same electrical data and standards.
SOFTWARE
In case of necessity we reserve the right to amend the described procedures during the software's
engineering phase, in order to simplify an easier or more user-friendly usage of the device or a more
coherent development of the software, without modifying the device's functional aspects.
INSTALLATION INSTRUCTIONS AND USER RESTRICTIONS
WIRING
The board's wiring has to be performed considering the necessity of keeping the low-tension cables
separated from the high tension ones.
The device has to be placed far from other equipment, like pumps, solenoid valves, remote-
control switches, motors in general, neon lamps, as their functioning could affect the
electromagnetic ambient.
AMBIENT
The device has to be placed as far as possible from heating sources and from excessive humidity, or
where there might be, for any reason, any condensation forming.
DIRT
The board inside the machine has to be adequately protected against dirt. As per definition "in general,
the interior of an appliance having a reasonably dust-proof enclosure is considered to be protected
against deposition of dirt" (EN 60335-1).
REMOTE- CONTROL SWITCHES
If external remote-control switch is used for a loading command, the connection of RC filters (or a
different device) could be necessary to support the interference issued during the loading switching.
SUPPUSHORS
SACOME, Document CONFIDENTIEL,
Edition 04/2017 - CG400
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 20 -