Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the
local voltage before connecting the device. Voltage 220V-240V
50/60Hz)
•
Caution! Run the blender no longer than 2 minutes continuous,
after 2 operation cycles always cool the blender for 10 minutes.
USE
•
Place the blender on a flat stable surface, not near a sink filled
with water or a similar setting. table, close the blender lid. Align
the triangle mark on the cup against the unlock mark on the body.
Twist the handle to the left to make the triangular mark of the cup
is aligned with the lock mark on the body.
•
Put food (for instance fruits or vegetables) in the blender jar and
add a certain amount of water (normal proportion between food
and water is 2:3). Make sure to never exceed the MAX mark on
the jar.
•
Push down the release handle when the suction nozzle is
directed at the air outlet of jar.
•
Insert the power supply in the socket.
•
Turn the knob to the on position, the light of the ON indicator and
the indicator of the function buttons pulse, ice, v blend and
vacuum light up. The machine is in standby modus.
The knob can be used for five optional functions;
•
ICE function: The motor works at highest speed, it turns on for
2.5 seconds and stops 1.5 seconds in 15 cycles. The program
then ends and the blender enters into standby modus. This
function can be stopped when the button is pressed again or the
knob is turned to OFF during program execution, the program will
not stop or switch if any of the other function buttons are being
pressed during program execution. After the program ends, first
press the switch to open the release handle, then unlock the cup
from the body.
•
V-blend function: After selecting this function, the machine will
start to vacuum and then blends for 1 minute. When the negative
pressure in the cup reaches the desired vacuum, the air pump
stops vacuuming. After 2 seconds, the motor runs at low speed
for 10 seconds and then at maximum speed for 50 seconds. The
program will then end and the blender will enter the standby
modus. If there is air leakage or the seal is not tight, the blender
will continue to pump for 70 seconds. If the negative pressure in
the cup has not reached the standard value, there will be a
flashing indicator light and a buzzer alarm, please check then the
seal before continuing. This function can be stopped when the
button is pressed again or the knob is turned to OFF during
program execution, the program will not stop or switch if any of
the other function buttons are being pressed during program
execution. After the program ends, first press the switch to open
the release handle, then unlock the cup from the body, press the
vent button on the vacuum lid until you don't hear the airflow
sound anymore. The vacuum lid can now be removed from the
jar.
Note:
•
Pay attention to place the lid correct on the jar before starting to
vacuum. The pouring nozzle of the vacuum lid should be
completely covered by the sealing ring, otherwise there may be
air leakage!
Instruction manual
EN
5
Publicité
Table des Matières
