System Settings; Troubleshooting - Panasonic RF-D10 Mode D'emploi

rf-d10eg.book Page 6 Friday, January 3, 2014 4:54 PM

System settings

█
To view the System menu
When in DAB mode
1
Press [MENU].
2
Turn [ TUNE/SELECT
then press [ENTER].
When in FM mode
Press [MENU].
█
To navigate around the menu
Turn [ TUNE/SELECT ] to select an item or option.
Press [ENTER] to confirm.
Example: Backlight setting displays
Indicates current setting
Alarm The Alarm Wizard is shown.
• Alarm: On, Off
Select "On" to switch on the alarm.
• On time: Set the hours and minutes of
start time.
• Source: Buzzer, DAB, FM
Set the audio source.
If FM or DAB is set, select the last
station you tuned in to ("Last listened")
or a preset station as the audio source.
• Set the volume
The alarm starts at a low volume and
increases gradually to the preset level.
" " is shown after you set the alarm.
Note:
• The alarm does not work when the unit is
powered by batteries.
• Check that the date and time are set
correctly, or else the alarm may not work
as desired.
• The alarm will come on at the set time
every day for a duration of 90 minutes.
Press any button or turn any knob to stop
the alarm.
• You need to set the alarm again every
time you disconnect and connect the AC
power or after you remove the batteries.
Sleep The sleep timer switches off the unit after
the set time (in minutes).
Sleep Off, 30 minutes, 60 minutes,
90 minutes, 120 minutes
" " is shown.
Equaliser Flat, Heavy, Soft, Clear, Vocal
" " is shown.
6
6
Time
] to select "System" and
Backlight
Language
Factory
Reset

Troubleshooting

General
Sound is distorted or no sound.
• Adjust the volume.
• Check and adjust the antenna.
• Move the unit to another location and do a full scan
• An AC mains lead or fluorescent light is near the
Reception is poor or beat sound is heard.
• Keep the antenna away from computers, TVs, other
Messages
"Service not available"
• No DAB reception.
"No DAB station"
• No DAB station available.
• Check the antenna.
• Move the unit to another location and do a full scan
"Time Not saved"
• The changes made to the time was not saved, the
"Alarm Not saved"
• The changes made to the alarm was not saved, the
The time and date information are
updated automatically with the DAB/RDS
broadcast (if available).
You can also set the time and date
manually with the Time menu.
This is a 24 hour clock.
• Set time: Set the hours and minutes.
• Set date: Set the day, month and year.
• 10 sec: The backlight switches off after
10 seconds of inactivity.
• On: The backlight is always on.
You can change the language for the
display panel.
English, Italiano, Deutsch, Français
Yes, No
Select "Yes" to reset the unit to factory
default setting.
again.
cables. Keep other appliances and cords away from
the cables of this unit.
cables and cords. Move mobile telephones away from
the unit if the interference is apparent.
again.
changes will be lost.
changes will be lost.
printing