Filtering Mode - sauter SHD601 Guide D'installation Et D'utilisation

EN
2 / INSTALLING YOUR APPLIANCE

Filtering mode

•
- Adjust the width of the support bracket (D) of the
telescopic flue by means of the screws (E) as
shown in fig. 7.
- Then, by means of the screw anchors and
screws (F) provided, fix the bracket to the ceiling
in such a way that it is positioned along the axis with
your hood.
- Mount the flange on the hood in correspondence
to the air outlet point (fig. 11).
- Take the air baffle and fit a flexible pipe to it (125
mm diameter) locking it with a metal hose clamp
(pipe and clamps are not provided); fit the air baffle
to the upper flue (fig. 12) with 4 screws.
- Insert the telescopic flues setting them on the
fig. 11
hood; extend the upper flue to the ceiling and
secure with the 2 screws H (fig. 10).
- Extend the lower flue taping it in place and then
connect the flexible pipe to the hood reduction
(fig.13).
- Plug in the hood.
- Extend the lower flue downward setting it against
the hood.
fig. 13
fig. 12
26