Complete Installation; Install Trim Piece - Whirlpool IH4302SS0 Instructions D'installation Et Guide D'utilisation Et D'entretien

Complete Installation

Install Vent Covers
Push the lower vent cover down onto the range hood and lift the
upper vent cover to the ceiling and install 4 - 3 x 9 mm screws.
E
C
A. Upper vent cover
B. Lower vent cover
C. Vent cover bracket
D. Install 3 x 9 mm screws.
E. Upper vent cover bracket

Install Trim Piece

1. Install the 3 trim brackets onto the top of the range hood
using 6 - 3 x 9 mm screws. Do not completely tighten the
screws, to allow adjustments.
A
A. Top of range hood
B. Trim brackets
D
A
B
D
B
2. Remove the protective film from the unpainted side of the
trim piece.
A
A. Protective film
3. Apply protective adhesive tape along one edge of the trim
piece on the unpainted side.
A
B
A. Protective adhesive tape
B. Correct adhesive tape location
4. Insert the trim piece with the protective adhesive tape side
facing out.
A
A. Protective adhesive tape side facing out
B. Painted side facing in.
5. Adjust brackets to firmly hold the trim piece and tighten all
screws.
B
9