Denon PMA-201SA Mode D'emploi page 6

ENGLISH
• System operations such as the timer reco ding/playback and auto power on functions can only be used if stereo
audio co ds and system cords are connected between all the system components. Be sure to securely connect all
the connection co ds between all the units.
• Disconnecting a system cord during system operation may result in malfunction. Be sure to unplug the power
cords before changing the connections.
2
Recommended System Installation
• To ensure performance and stability, install the system (201SA series) as shown below.
OW R O D N ME H N M
N / T N BY 5
(DMD-201SA)
C
N / T N BY 5
(DCD-201SA)
✽ Do not place another component directly on top of the PMA-201SA. To allow for heat dispersal, leave a space of at
least 10 cm above the PMA-201SA so as not to obstruct its ventilation holes.
✽ For stability, do not stack more than three components on top of each other.
6
System Operations
O / T N BY ¡ O F M DE O RC D R CT
P O ES F N T N
N EG A ED A PL I R PMA 0 SA
1 3 2
D
M
NP T H R C ER E T CD RS U T EC ON T N BY I ER B ND R S
I I I C R COR ER D D 2 1SA AM M ST RE
1 3 2 1
D
ON T N BY 5 NR
OM ACT SC P A ER D D 2 1SA ST R O CA SE TE A E DE K DRR 0 SA
Connecting Speaker Systems
2 Speaker impedance
Use speaker systems with an impedance of 4 to
16Ω/ohms.
• Note that using speakers with other impedances will
activate the protector circuit and may result in
damage.
Protector Circuit
VO UME
(PMA-201SA) The PMA-201SA is equipped with a high
speed protector circuit.
This circuit prevents strong currents
from being generating inside the unit
N
M MO Y S T and damaging internal circuitry if the
(TU-201SA)
speaker cables are not securely
TU ER TU 0 SA
connected to the speaker terminals or if
they are short-circuited. If the protector
2
circuit is activated, the speaker output is
E E S 4 EC
R S T D RS R C U E
(DRR-201SA)
automatically cut off. If this happens,
turn off the unit's power, check the
speaker cable connections, then turn the
power back on. The sound will be muted
for several seconds, after which the unit
will operate normally.
2 Connecting the speaker cords
q Peal off the coating f om the tip of the cord.
w Twist the core wire.
e Turn the speaker terminal counterclockwise to
loosen it.
r Completely insert the core wire, then turn the
terminal clockwise to tighten it.
q w e r
B Be sure to connect the speaker co ds to the terminals
with the same polarities on the speaker and amplifier
( < to <, > to > ).
B When connecting, make sure that the speaker cords'
core wires do not stick out and touch other terminals,
other core wires or the rear panel.
NOTE:
• NEVER touch the speaker terminals while he set is
connected to a power supply. Doing so may result in
electric shock.