Assembly And Operation; Applications; Removal And Installation Method Of Battery - Metabo HPT RB 18DSL Instructions De Sécurité Et Mode D'emploi

ASSEMBLY AND OPERATION

APPLICATIONS

○ Cleaning house etc.
○ Blowing operation.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○ How to install the battery.
Align the battery with the groove in blower
handle and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally
fall out of the blower, causing injury to you or
someone around you (Fig. 2).
○ How to remove the battery.
Withdraw battery from the blower handle while
pressing the latch (2 pcs) of the battery (Fig. 2).
Battery
(Optional accessory)
CHARGING
For rechargeable batteries, please charge in
according to the handling instructions of the charger
which you are using.
BEFORE USE
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.
Handle
Latch
Push
Pull out
Insert
Fig. 2
MOUNTING AND DISMOUNTING THE
NOZZLE
○ Mounting the NozzIe
Insert the pin located outside the nozzle into
the notch provided on the blast port, and fully
turn the nozzle in the direction indicated by the
arrow in Fig. 3.
To dismount the nozzle.,folIow the above
procedures in reverse.
Pin
Nozzle
Blast port
HOW TO USE THE CORDLESS
BLOWER
○ Switch operation
When the trigger switch is depressed, the
blower rotates. When the trigger is released,
the blower stops.
English
Notch
Fig. 3
9