Maintenance And Inspection - Metabo HPT RB 18DSL Instructions De Sécurité Et Mode D'emploi

English

MAINTENANCE AND INSPECTION

CAUTION
Pull out battery before doing any inspection or maintenance.
1. Check the Screws
Loose screws are dangerous. Regularly
inspect them and make sure they are tight.
CAUTION
Using this blower with loosened, screws is
extremely dangerous.
2. Maintenance of the motor
The motor unit winding is the most important
part of the blower.
Exercise due care to ensure the winding does
not become damaged and/or wet with oil or
water.
3. Check for Dust
Dust may be removed with a soft cloth or a
cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner,
for they may damage the plastics.
4. Storage
Storing in a place below 104°F (40°C) and out
of the reach of children.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been
fully charged before storing them.
Prolonged storage (3 months or more) of
batteries with a low charge may result in
performance
reducing battery usage time or rendering the
batteries incapable of holding a charge.
However, signifi cantly reduced battery usage
time may be recovered by repeatedly charging
and using the batteries two to fi ve times.
If the battery usage time is extremely short
despite repeated charging and use, consider
the batteries dead and purchase new batteries.
5. Service and repairs
All quality blower will eventually require
servicing or replacement of parts because
of wear from normal use. To assure that only
authorized replacement parts will be used,
all service and repairs must be performed
by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.
10
deterioration, signifi cantly
CAUTION
In the operation and maintenance of
blower, the safety regulations and
standards prescribed in each country
must be observed.
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when
used with batteries other than these designated
by us, or when the battery is disassembled and
modifi ed (such as disassembly and replacement
of cells or other internal parts).