Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9.
Place screen down into hopper.
the clips in bottom of hopper at this time. See figure 6.
10.
Place motor assembly down into hopper, inserting end of
spreader shaft into impeller coupler. Secure it with a 1/8"
x 1-1/4" cotter pin, spreading ends of pin around coupler.
See figure 5.
11.
Fasten motor mount bracket to hopper using four 5/16" x
1" hex bolts, 5/16" flat washers, nylon washers and 5/16"
nylock nuts. See figure 5.
MOTOR
ASSEMBLY
5/16"
NYLOCK NUT
NYLON
WASHER
5/16" x 1"
HEX BOLT
5/16" FLAT
WASHER
FIGURE 5
12.
Lift screen up and slide seal down spreader shaft to rest
against plastic bushing in bottom of hopper. See figure 6.
13.
Slide one edge of the screen under one of the clips.
Then, slightly bow the screen to slide the opposite
side of the screen under the other clip. See figure 6.
CLIP
SCREEN
FIGURE 6
DO NOT place it under
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
SCREEN
SHAFT
SEAL
BUSHING
CLIPS
14.
Attach the control mount tube to the top of the
spreader using a 5/16 x 1" hex bolt and 5/16" nylock
nut. See figure 7.
NOTE: The end of the control mount tube with the smaller
bend should be attached to the spreader.
5/16" NYLOCK NUT
FIGURE 7
15.
Attach the flow control to the control mount bracket
using a 5/16" x 1" hex bolt and a 5/16" nylock nut.
See figure 8.
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
FIGURE 8
5
5/16" x 1"
HEX BOLT
Publicité
Table des Matières
