Unold SOFTI Notice D'utilisation page 30

DE
EN
FR
NL
IT
ES
PL
Valve closed
the appliance.
10. Caution: The appliance must be completely assembled and switched on before
you add the desired ingredients. Never put the required ingredients into the
30 von 104
Copyright UNOLD AG | www.unold.de
the appropriate unlock/lock marking on the underside
of the appliance. You will hear a click when the dis-
charged valve is placed correctly.
4. Fit the upper part of the housing onto the lower part of
the housing. Note that the feet on the upper part of the
housing must be slide precisely into the arms of the
lower part of the housing.
5. Then the cooling container with ring must be inserted
into the upper part of the housing. There is a small tab
on the ring that precisely fits into the corresponding
aperture on the upper part of the housing. This is the
only way to precisely insert the cooling container and
placing the appliance in operation.
6. Now place the motor on the lid. The motor can only be
placed on the lid in one position. Note that
the two locking tabs on the motor must lock
into the corresponding apertures on the lid.
7. Fit the mixer into the aperture on the under-
side of the motor. Ensure that the mixer locks
in place and is firmly seated, it may be neces-
sary to exert some pressure here.
8. Place the lid with motor and mixer in the upper part of
the housing/cooling container. The motor must by on the
rear part of the housing (see Fig.), and the three locking
tabs of the lid must be turned into the apertures on the
ring. The lid is correctly locked when it can no longer be
Valve open
lifted off of the appliance.
9. Caution: Before each use,
ensure that the discharge valve
is sealed. The lever must be
pressed upward to the "Close"
position. If you press the lever
downward, the valve is open
and the ingredients flow out of
Stand 20.2.2020