Assembling The Appliance And Making Ice Cream - Unold SOFTI Notice D'utilisation

2. The cooling container must only be placed in a vertical position at the cold-
est point in the freezer compartment. Through the two small straps of the
ring you can conveniently take the cooling container out of the cooling com-
partment, without coming into direct contact with the ice-cold container.
3. Tip: If the cooling container with ring is too bulky for the freezer compart-
ment, you can take the ring off of the cooling container. To do this, carefully
press the ring downward, until it detaches from the cooling container and
can be taken off (if necessary turn slightly clockwise).
4. The freezing process takes between 8 and 22 hours depending on the tem-
perature of the freezing device. By shaking the container you can determine
whether the entire cooling liquid is frozen.
5. Tip: When you are not using the ice cream machine store the cooling con-
tainer, in a plastic bag, for example, in the freezing device, thus the con-
tainer is always ready for use.
6. If you want to make several types of ice cream in succession, we recommend
that you purchase additional cooling containers. You can order them directly
from us, an order form is provided on page 115.

ASSEMBLING THE APPLIANCE AND MAKING ICE CREAM

The desired ingredients should have already been pre-cooled for several hours prior
to preparation! If you are using alcohol for the recipe, please only add it to the ice
cream when the ice cream has the desired consistency.
1. Insert the cooling container in the ring. To do this, pull the ring upward from
the underside of the cooling container, until the ring is firmly seated on the
cooling container (if necessary turn slightly counter-clockwise).
2. Place the cooling container in a freezer compartment for at least 8 hours.
The temperature should be -18°C or colder. Also comply with all other
instructions in the chapter, „Before preparing ice cream".
Stand 20.2.2020
Copyright UNOLD AG | www.unold.de
3. If necessary, insert the dis-
charge valve. To do this, turn
the upper part of the housing
upside down. Insert the valve
unit into the appropriate aper-
tures and turn the valve coun-
ter-clockwise. Pay attention to
DE
EN
FR
NL
IT
ES
PL
29 von 104