Input Selection And Av Connections - Input And Output Sockets For Connected Equipment - Toshiba REGZA WL66 Série Manuel De L'utilisateur

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
B
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g. 2S (EXT 2S), indicates the
B
input is set for an S-Video signal.
Input selection
Use the Input Selection if the television does not switch
over automatically.
Press to select
B B
1
HDMI1, HDMI2 or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press
2
one of the numbered buttons.
Input selection and
AV connections
1, 2, 3(C) (EXT1-3),
B B
again or
B
INPUT signal selection
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press down until
1
AV connection is highlighted, then press OK.
Language
Country
Auto tuning
Manual tuning
AV connection
Picture position
Back
MENU
With left or right select either AV or S-VIDEO as
2
the required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
EXT2 input
Monitor (Audio)
Back
MENU
If the colour is missing try the alternative setting.
22
SET UP
English
UK
OK
OK
OK
OK
Watch TV
EXIT
AV connection
PC
Digital
S-VIDEO
Fixed
Watch TV
EXIT
1/2