Software Installation; Software Applications; System Requirements - Trotec BL 30 Notice D'emploi

15 . The message „-LO-" indicates that the sensor for the
temperature and humidity is not correctly connected .
In this case, you can proceed as follows: Open the back
of the appliance and connect the sensor correctly . As
soon as the sensor is correctly connected, the message
disappears and the appli-ance is ready for operation
once again . If this action is unsuccessful, please contact
our customer service department .

5. Software installation

1 . First of all, insert the CD supplied into the CD-ROM
drive . A pop-up menu appears shortly afterwards .
Follow the instructions in the menu to install the
software on your PC .
2 . Leave the CD in the drive even after completion of
the software installation . Connect the data logger to
your PC using the USB cable supplied . A window for
the USB driver is opened . Follow the instructions
and select the path for the USB driver (CD drive) . The
installation takes place shortly afterwards .

Software applications:

You can transfer the collected measured data to your
PC with the data logger's USB software . The program
supports Excel or similar spreadsheet programs . The
data can also be displayed graphically . The most impor-
tant functions can all be seen in the superordinate main
window .

System requirements:

Windows 2000 /Windows XP/Vista, Windows 7
Minimum hardware requirements:
PC or Notebook with Pentium 90 MHz processor or high-
er; 32 MB RAM; At least 7 MB free hard disk space for
the installation of the HT data logger USB software . The
recommended display resolution is 1024 x 768 with high
colour (16 bits) .
operating instructions - climate data logger Bl30 B - 5