Geemarc CL2 Notice D'utilisation page 7

4 - ALARM OPERATION
4.1 - RINGER SETTING
Choose which alarm mode you want by moving the alarm mode switch to
one of the following positions:
0 : no alarm
: both strobe flasher and sound alarm activated
: both strobe flasher and shaker (if connected) activated
: both sound alarm and shaker (if connected) activated
4.2 - VOLUME CONTROL SLIDE SWITCH
Set the volume of the alarm sound.
4.3 - RING TONE CONTROL SWITCH (3 POSITIONS)
Set the tone of the ringer alarm sound (incoming call).
4.4 - DOOR BELL TONE CONTROL SWITCH (3 POSITIONS)
Set the tone of the door bell alarm sound.
4.5 - USE THE DOOR BELL
To use the door bell simply press the door bell button, CL2 will work with the
alarm settings, alarms will work only when pressing the door bell button
(two alarm for each time you press).
TROUBLE SHOOTING
The phone ring not
the CL2
The door bell doesn't - AC/DC adaptator must be pluged
send alarm
- Ckeck the right connexion between the wall
socket and CL2 "Line In" plug
- Check that the ring button is not set on "without"
- Open the door bell, check the battery position + -
- check that the 8 switches setting is the same as
in the CL2