Geemarc CL2 Notice D'utilisation page 4

DOOR BELL
1 - DOOR BELL WALL MOUNT
The door bell is supplied with a 23A 12V battery , it is not necessary to open
the door bell to set the battery.
Note: The door bell works only when you press the button.
To wall mount the door bell simply follow instructions below:
- Use the wall mount template to mark the holes on the wall (screws and
pins are provided with the CL2).
- Open the screw wall mount access cover located in the middle of the door
bell with a small needle or a small screw driver, there is a little hole to introduce
the needle or the screw driver into the cover.
Place and align the two holes in the same axes as the holes on the wall,
insert the screw, then replace the cover. The Door bell is now ready to use.
Note: Do not place the base and the door bell onto metallic base or
near electric equipment (like TV, Radio, computer, washing machine...).
The CL2 will work within a range of 60 m in an environment where
there are no obstacles and 20 m in an environment which contains a
wall or metallic structure.
Screw wall mount
access cover
with name
template
2 - CHANGE THE BATTERY
To replace the battery, remove the door bell from the wall, unscrew the three
screws located on the base and open the box to get access to the battery
compartment. Replace the battery.
Close and screw the box with the screw, and wall mount it again. Pay attention
to the two plastic parts A and B for which make this appliance waterproof.
Wall mount holes
Door Bell
Button