Puky F20 Mode D'emploi page 5

1. Introduction
Congratulations for purchasing this PUKY
go-cart. You have bought a product that
will give your child pleasure and fun. The
information in this user manual will help you
operating the new go-cart in a safe way
and inform you how to do service work. If
you have any questions or encounter any
problems please contact your local dealer
or visit our web site at: www.puky.de.
2. Parent's responsibilities
This go-cart was manufactured in
compliance with European Norm EN
71, and carries the CE symbol.
If your child uses the go-cart for the pur-
pose it was designed for, there will be only
a minimum risk of hazard when riding the
go-cart. Remember, children's natural play-
ing needs and their temperament may cause
unforeseen situations which can be danger-
ous and result in serious injuries. This is not
the liability of the manufacturer. So, do teach
your children how to use the go-cart prop-
erly and direct attention to potential risks.
3. Warnings
It is essential that closed shoes are worn
when using the go-cart. Do not wear loose
clothing, as this might be damaged by the
rear wheels. Long shoelaces could get caught
up in the pedals. When reversing quickly, the
User Manual
go-cart could tilt backwards if the brakes are
applied sharply. If children use the go-cart,
care should be taken that they are nowhere
near stairs, hilly terrain, swimming pools and
other water. Surrounding stairs and steps
should be suitably cordoned off to prevent
children ascending or descending these.
4. Use
Please use the go-cart in a suitable play area
or safe environment. The go-cart does not
correspond to German Road Safety Stand-
ards and must not be used on public roads.
The total loads permissible for this go-cart are
as follows:
F 20L = 30 kg,
F 50 to F1 = 50 kg
5. Care and maintenance
Following the "DRIVING IN PERIOD" of sev-
eral hours, please check the chain tension
and, if necessary, adjust this. To adjust the
chain, the chain guard does not need to be
removed (apart from with the GF 20). All you
have to do is loosen the nuts on the gear ec-
centric discs on both sides of the gears and
the disc evenly turned backward. For the
GF 20, you must remove the chain guard,
the nuts on the gear bearing clamps slightly
loosened and both sides evenly adjusted.
Then the nuts are firmly tightened again.
5
GB